How to install INSITE 8.2.0.184 on Cummins Inline 5 data link?
Need:
- Exit all anti-virus software programs
2.Setup Cummins 8.2.0 pro/lite version software
How to Install Activate Cummins Insite 8.2.0.184 Pro and Lite
Procedure:
Step 1: setup Inline 5 driver
Any of windows 7 8 10 is okay, I take Windows 7 32-bit for example.
Open software CD
Open INSITE.7_6_2.rar-> Software folder->INSITE 5 Drivers
Copy Inline 5.7.0.1 Setup- 32 Bit.exe and paste it to the desktop
For 64-bit system, you copy Inline 5.7.0.1 Setup- 64 Bit.exe to desktop
Setup the adapter driver, I use Cummins Inline5 data link (Inline 6, Nexiq or other adapters are working too)
Run Inline 5.7.0.1 Setup-32 Bit on desktop as administrator
Click on NEXT
Accept the windows security warning to setup driver software
Tick "Launch Inline 4/5 Reflash Tool" and click on Finish
Delete Inline 5.7.0.1 Setup-32 Bit on desktop
Device driver has been successfully installed
Open Computer->Manager->Device Manager->Universal Serial Bus Controller to check if the driver establishes a good communication with the computer.
Step 2: Add Inline5 adapter to INSITE 8.2.0
Open INSITE 8.2.0.184 pro or lite version software on desktop
Select "Add New" option on the middle of the bottom tool bar
Click on "Next" to setup ECU Connection Wizard
Choose RP1210 adapters, click on Next
Choose Vendor, Adapter INLINR 5 USB and protocol Auto detect, click on Next
Click on Next
Tick both 2 options and click on Finish
Again software will prompt to install ECU connection wizard, click on NEXT
Do the same setting as above, but this time we choose protocol J1708
Click on Finish
Do the setting again, this time we add protocol J1939
Click on Finish and cancel ECU connection wizard interface
Please add the corresponding adapter in the insite software
Choose "INLINES USB (Auto Detect) Connection" in the middle of bottom tool bar
Click on the "Connect" button to connect to ECM
Now you are ready to use the software to read fault code, manage data logger, do calibration etc
