FVDI J2534 Tech Support
FVDI J2534 is very simple to use and easy to install. You only need to do two steps to Installs
software. First,Install FVDI J2534 start software,then install the original brand vehicle
software,For example, Ford, Mazda, Honda, Toyota. However, it is important to note that
these software cannot be installed in the same computer If you want to use these software
via FVDI J2534 equipment, please install different software on different computers.
Note: the software installation are not required installation sequence.
System Requirements:
Get FVDI J2534 equipment software from compact disc(CD)
Put the CD in the computer CD drive
Wait a while before opening the CD in the resource manager,you will see the equipment
related software and resources.
Get FVDI J2534 equipment software from official website download link
Access to http://flyobd.com/download-center/
Please register and log in
Download FVDI-J2534-FM (FM,Short for Ford and Mazda)
Download IDSFord or IDSMazda
Download the latest release IDS software and save it to local.
Double-click the “IDS-110.01_Full.exe” to start installation
Select language,and click “next” button
Wait a while,and the following windows will pop out,click “Yes”,then click “next”
Select “i accept the terms of the license agreement”, and then click “next”, and then
click “next”, and then click “install”. The installation process will take some time,please
wait patiently.
Reboot your computer after installation
Install the FVDI J2534 software
Open compact Disc and find FVDI-J2534 software and double-click the
“FVDI_J2534_Ford_Setup.exe” software
Select Setup Langeuage and Click “Ok”
It will install SVCI Based software list, Click “next” directly, and then Click “next” all the
time untill it jump a window “Select Setup Language”, which is selected the device
driver’s installtion language.
Install the device driver,and click “Next” all the time untill install Shield wizard complete, and then click “finish”.
When you open FVDI J2534 for ford software after installtion, an error window will pop
out. That means you have not connect FVDI J2534 equipment with your computer, as
show in the below. connect your device with computer,and the FVDI J2534 software will
be opened normally
when you put FVDI J2534 equipment to connect the computer and open the software,
it will pop below error message, it means you do not connected vehicle ECU module and
the ECU voltage can not less than 8 volts. After using the OBD interface of FVDI J2534 to
connect the ECU,and the software can be opened normally and put into use.
Note: Cannot open the IDS software on the desktop directly,it is recommmended to delete
the IDS software shortcut on the desktop.