Launch X-Prog3 PC Adapter Clone Infiniti Gearbox Computer Step by Step

Matched product:

Launch X431 IMMO Programmer X-PROG3 PC Adaptor Supports Engine Data Validation Function

US$159.00€149.98£130.33円24,486.00AU$248.44C$223.95

• Item No. SK412
• Free Shipping

The Launch X431 X-prog3 PC adapter used in conjunction with X-PROG3 immo programmer,support read/write ECUs data quickly, including read the chip ID and back up the EEPROM data, back up the FLASH data and restore EEPROM/FLASH data

Use the Launch X-PROG3 PC Adaptor and X431 X-Prog3 to clone Infiniti VGS2-FDCT gearbox computer on bench, works like a charm!

Here is the operation process:

Connect the X-PROG3 PC ADAPTOR to the computer using a USB cable, and then connect the X-PROG3 PC ADAPTER to G3.

Run X-PROG3 PC Adaptor PC Software

Note: For the first time using, need to activate device with serial number and activation code. Just follow the prompt to operate.

Input vgs2-fdct in the search boxF

Quickly obtain the desired ECU model: Infiniti Q30 2015-2016 ENE 2200 CDI AWD 170 VGS2-DCT TC1784.

Click the ECU to enter the operation page

First, click [Direct Connection Diagram] to obtain the ECU connection diagram, and then connect the VGS2-FDCT gearbox computer and Launch X-Prog3 PC Adapter via the professional bench cable (jumper) or X-PROG3 Adapter Cable 8 (VGS2-FDCT/VGS-FDCT), and supply power to XPROG3 PC Adapter as well

Then, click “Connect” to read the chip ID

Next, Read EEPROM data and FLASH data in sequence, and save the original data file after reading

After that, connect X431 XPROG3 PC Adapter to a new Infiniti VGS2-FDCT gearbox computer, select the corresponding original EEPROM and flash data file to write into the new ECU

Finally, disconnect

All work fine!

Launch X431 ECU & TCU Programmer with its PC software also can perform the same function for Infiniti VGS2-FDCT gearbox computer, no need to work with X431 X-Prog3 GIII key programmer and X431 tablet.